徐杰,王久林,周敏,等.小尺寸梯形凸台曲轴盖板成形工艺研究[J].精密成形工程,2015,7(4):16-21.
XU Jie,WANG Jiu-lin,ZHOU Min,et al.Process of Small Size and Trapezoid Convex Platform of Crankshaft Cover[J].Journal of Netshape Forming Engineering,2015,7(4):16-21. |
| 小尺寸梯形凸台曲轴盖板成形工艺研究 |
| Process of Small Size and Trapezoid Convex Platform of Crankshaft Cover |
| 投稿时间：2015-06-12 修订日期：2015-07-10 |
| DOI：10.3969/j.issn.1674-6457.2015.04.004 |
| 中文关键词: 曲轴盖板 拉深 整形 梯形凸台 |
| 英文关键词: crankshaft cover drawing shaping trapezoid convex platform |
| 基金项目: |
|
| 摘要点击次数: 4892 |
| 全文下载次数: 4070 |
| 中文摘要: |
| 目的 研究汽车曲轴盖板复合加工工艺的可行性。 方法 根据零件特点,采用多道次拉深和整形相结合的加工工艺成形零件,并利用有限元技术,对成形过程进行了数值模拟分析,然后结合物理实验对工艺可行性进行了验证。 结果 试制出的零件表面质量较好,法兰内缘处梯形凸台尺寸精度达到了要求,和有限元仿真模拟结果相吻合。 结论 采用多道次拉深和整形复合工艺所获得的汽车曲轴盖板,完全满足零件实际使用要求,成形工艺有效、可行。 |
| 英文摘要: |
| The aim of this study was to investigate the feasibility study of the cover of automobile crankshaft machining process. According to the characteristics of the part, parts were assembled by machining process combined with multi pass drawing with shaping, and the numerical simulation of forming process was analyzed by the finite element technology. Fi- nally, the feasibility of process was verified using physical experiments. The surface quality of the trial is good, the size precision of the trapezoidal bulge at the inner edge of the flange meet the requirements, which was consistent with the finite element simulation results. The automobile crankshaft cover board processed by multi-pass drawing and plastic composite technology can fully meet the requirements of the actual use , and the forming process is effective and feasible. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号