毕宝鹏,王勇.5A06 铝合金板材超塑气胀成形数值模拟[J].精密成形工程,2014,6(6):99-103.
BI Bao-peng,WANG Yong.Numerical Simulation on 5A06 Aluminum Alloy Sheet by Superplastic Gas Bulging Forming[J].Journal of Netshape Forming Engineering,2014,6(6):99-103. |
| 5A06 铝合金板材超塑气胀成形数值模拟 |
| Numerical Simulation on 5A06 Aluminum Alloy Sheet by Superplastic Gas Bulging Forming |
| 投稿时间：2014-10-02 修订日期：2014-11-10 |
| DOI：10.3969/j.issn.1674-6457.2014.06.016 |
| 中文关键词: 5A06 铝合金 正反胀形 壁厚均匀度 |
| 英文关键词: 5A06 aluminum alloy positive and negative bulging forming wall thickness evenness |
| 基金项目:国家国际科技合作专项资助(2013DFR70860) |
|
| 摘要点击次数: 4516 |
| 全文下载次数: 4047 |
| 中文摘要: |
| 目的 改善5A06 铝合金板材超塑性气胀成形件壁厚分布。方法 采用MARC 有限元分析方法,对商业供货态5A06-O 铝合金板材( 原始厚度为2 mm) 的超塑性成形进行数值模拟分析。结果 优化后的反吹预减薄变形,使杯形件最终壁厚分布大大改善,最薄处壁厚从单纯正吹胀形时的0. 65 mm 提高到了0. 94 mm,壁厚均匀性指数达到0. 079。结论 合理的反胀形模具可以增加最小壁厚,达到提高壁厚均匀性的目的。 |
| 英文摘要: |
| Objective Improvement of 5A06 aluminium alloy plate superplastic gas bulging forming wall thickness evenness. Methods The results of commercial supply state 5A06-O aluminum alloy sheet's (original thickness 2 mm) superplastic forming show that the uneven distribution of wall thickness of forming parts by using the method of MARC finite element analysis. Results The results show that the optimized blow the thinning deformation is greatly improve the cylindrical pieces of the final wall thickness distribution, the most in thin wall thickness from the simple was blowing bulging of increased by 0. 94 mm, 0. 65 mm wall thickness evenness index is 0. 079. Conclusion Reasonable the bulging die can in- crease the minimum wall thickness, achieve the goal of increasing wall thickness evenness. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号