乔硕,石文超,王炯,等.汽车空调压缩机驱动盘冷挤压的 Deform 模拟[J].精密成形工程,2013,5(3):65-68.
QIAO Shuo,SHI Wen-chao,WANG Jiong,et al.The Deform Simulation on Cold Extrusion Process of Compressor Driving Plate of Conditioner in Automobile[J].Journal of Netshape Forming Engineering,2013,5(3):65-68. |
| 汽车空调压缩机驱动盘冷挤压的 Deform 模拟 |
| The Deform Simulation on Cold Extrusion Process of Compressor Driving Plate of Conditioner in Automobile |
| 投稿时间：2012-09-10 修订日期：2013-04-01 |
| DOI：10.3969/j.issn.1674-6457.2013.03.015 |
| 中文关键词: 汽车空调 压缩机 驱动盘 冷挤压 数值模拟 |
| 英文关键词: automobile conditioner compressor driving plate cold extrusion numerical simulation |
| 基金项目: |
|
| 摘要点击次数: 4695 |
| 全文下载次数: 3784 |
| 中文摘要: |
| 采用冷挤压工艺成形汽车空调压缩机驱动盘。 用 Deform-3 D 软件对冷挤压过程进行数值模拟,分析了冷挤压成形过程金属流动、等效应变和速度分布等规律。 结果表明,用冷挤压工艺成形驱动盘,成形载荷小,充填效果好,材料利用率较高。 |
| 英文摘要: |
| The compressor driving plate of automobile conditioner is formed by cold extrusion technology. The cold extrusion process was simulated by Deform-3D. And the metal flow, effective stain and rate distribution in cold extrusion were investigated. The result shows that the cold extrusion process is beneficial for the filling condition with a relative low forming load. The material utilization rate is relatively high. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号