周鹏,刘兰俊,王辉,等.低碳中合金钢破碎机锤头的研制[J].精密成形工程,2013,5(1):78-80,84.
ZHOU Peng,LIU Lan-jun,WANG Hui,et al.Study on the Crusher Hammer with Low Carbon and Medium Alloy Steel[J].Journal of Netshape Forming Engineering,2013,5(1):78-80,84. |
| 低碳中合金钢破碎机锤头的研制 |
| Study on the Crusher Hammer with Low Carbon and Medium Alloy Steel |
| 投稿时间：2012-06-10 修订日期：2012-12-01 |
| DOI：10.3969/j.issn.1674-6457.2013.01.020 |
| 中文关键词: 破碎机锤头 热处理 马氏体 力学性能 |
| 英文关键词: crusher hammer heat treatment martensite mechanical property |
| 基金项目: |
|
| 摘要点击次数: 5101 |
| 全文下载次数: 4235 |
| 中文摘要: |
| 研究了一种新型的破碎机锤头,对其采用合金化处理并经过热处理,实验表明:该低碳中合金耐磨钢的硬度大于 51 HRC,冲击韧性大于 141 J / cm2。 经热处理后的显微组织为回火马氏体+残余奥氏体+弥散的碳化物,比高锰钢破碎机锤头性能有很大提升。 |
| 英文摘要: |
| A new crusher hammer was made. The composition was optimized by alloying and then it experienced heat treatment technology. The results were as follows, this low carbon and medium alloy steel has good properties. The hardness of the steel is HRC >51, impact toughness is ak>141 J / cm2. After heat treatment the microstructure composed of the mixture of tempered martensite, a small amount of residual austenite and carbide dispersion. Compared with the crusher hammer produced by high manganese steel, the properties were greatly improved. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号