王波,李名尧,孙劲松,等.曲轴模锻成形工艺分析及模具优化[J].精密成形工程,2012,4(6):56-60.
WANG Bo,LI Ming-yao,SUN Jing-song,et al.Die Forging Process Analysis and Mold Optimization of Crankshaft[J].Journal of Netshape Forming Engineering,2012,4(6):56-60. |
| 曲轴模锻成形工艺分析及模具优化 |
| Die Forging Process Analysis and Mold Optimization of Crankshaft |
| 投稿时间：2012-09-10 修订日期：2012-11-10 |
| DOI： |
| 中文关键词: 曲轴 数值模拟 成形工艺 模具优化 |
| 英文关键词: crankshaft numerical simulation forging process mold optimization |
| 基金项目:上海市教育委员会科研创新项目（12ZZ183）；上海工程技术大学研究生科研创新项目（2011yjs15） |
|
| 摘要点击次数: 4127 |
| 全文下载次数: 3750 |
| 中文摘要: |
| 采用有限元方法对曲轴锻造成形工艺过程进行数值模拟，主要分析不同的飞边槽结构对曲轴预锻成形中坯料的充填情况及成形载荷的影响。根据模拟结果可知，在飞边槽桥部合理增设阻力沟或阻力墙，将对曲轴平衡块的充填性有很大程度的改善，并优化了毛坯尺寸。 |
| 英文摘要: |
| By using FEM numercial simulation, the forging process of crankshaft is studied. The different structures of fash slot are mainly considered in the pre-forging process, in order to analyze the situation of the blank filling and the forging load. According to the results of numercial simulation, the structure of resistance ditch or resistance wall is reasonably added in the bridge of fash slot, which will greatly improve the filling of crankshaft's balance block, and finally optimize dimension of the blank. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501719号