庄仲凯,王强,谈玉龙,等.径-轴向辗环机轴向轧制机构结构分析[J].精密成形工程,2012,4(5):30-36,62. ZHUANG Zhong-kai,WANG Qiang,TAN Yu-long,et al.Structure Analysis of Axial Rolling Assembly of Radial-axial Ring Rolling Mill[J].Journal of Netshape Forming Engineering,2012,4(5):30-36,62. |
径-轴向辗环机轴向轧制机构结构分析 |
Structure Analysis of Axial Rolling Assembly of Radial-axial Ring Rolling Mill |
投稿时间:2012-08-24 修订日期:2012-09-10 |
DOI: |
中文关键词: 径-轴向辗环机 轴向轧制 装配体 有限元 结构分析 |
英文关键词: radial-axial ring rolling mill axial rolling assembly FEM structure analysis |
基金项目:“高档数控机床与基础制造装备”科技重大专项项目(2010ZX04004-131-06),山东省自然科学基金重点项目(ZR2012EEZ001) |
|
摘要点击次数: 4234 |
全文下载次数: 3168 |
中文摘要: |
采用三维造型软件SolidWorks建立了某型号径-轴向辗环机轴向轧制机构的实体模型。以有限元软件ANSYS为分析平台,通过合理处理接触、约束和载荷等边界条件,建立了有限元分析模型,对轴向轧制机构进行了三维弹性接触分析,得到了轴向轧制机构及主要部件的等效应力、位移变形、等效应变。对变形角进行了定义,提出了求解变形角的方法。计算结果表明,变形角为0.041°时,各部件的最大等效应力均小于屈服极限,轴向轧制机构刚度符合设计要求,各部件满足强度要求。 |
英文摘要: |
Using SolidWorks,axial rolling assembly model of ring rolling mill was built. Using ANSYS,finite element analysis model was established through processing contact and constraints and loads,then three dimensional elastic contact was analyzed to the axial rolling assembly and the equivalent stress, strain and deformation displacement of axial rolling assembly and its parts were got. Deformation angle was defined and the method how to solve the deformation angle was put forward. The result shows that deformation angle is only 0.041° and the maximum stress of various components is less than the yield limit,so the rigidity of the ring rolling mill meets the design requirement and its parts meet strength requirement. |
查看全文
查看/发表评论 下载PDF阅读器 |
关闭 |