李维明,李四娣,罗金祺.滤波器腔体压铸技术的研究和应用[J].精密成形工程,2011,3(4):76-78.
LI Wei-ming,LI Si-di,LUO Jin-qi.Research and Application of Filter Housing for Aluminum Alloy Die-casting Technology[J].Journal of Netshape Forming Engineering,2011,3(4):76-78. |
| 滤波器腔体压铸技术的研究和应用 |
| Research and Application of Filter Housing for Aluminum Alloy Die-casting Technology |
| 投稿时间：2011-02-13 修订日期：2011-07-10 |
| DOI： |
| 中文关键词: 滤波器 共鸣信号柱 气孔 缩孔 冷隔 |
| 英文关键词: filter housing signal pillar porosity shrinkage hole cold shut |
| 基金项目: |
|
| 摘要点击次数: 3947 |
| 全文下载次数: 3321 |
| 中文摘要: |
| 简要分析了滤波器腔体具有内腔共鸣信号柱多而孤立且内腔深的特点，该滤波器腔体在压铸成形过程中极易产生冷隔、气孔和缩孔，导致加工后，凸柱表面出现很多微孔，影响产品功能。提出了滤波器腔体的模具设计、压铸工艺以及修补处理等新方案，使滤波器腔体的共鸣柱加工后微孔明显减少，提高了产品的合格率，成功解决了多条相互不相连的共鸣信号柱的深腔滤波器铸件的压铸。 |
| 英文摘要: |
| Cold shuts, porosity and shrinkage holes would appear easily in a kind of filter housing if it is manufactured by high pressure technology because there are a lot of signal pillars in the deep housing and all the signal pillars in the deep housing aren't connected each other. So lots of micro-small holes appear at the top of those pillars after machining and they would affect their function heavily.It was studied how to solve those problems by die-designing, technology and other repairing technology in post processing. Eventually, those problems were solved perfectly, the defective rate had been decreased to a low number which could be accepted. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号