吴梦陵,伍太宾.成形工艺参数对塑件翘曲影响研究[J].精密成形工程,2010,2(6):19-23,50.
WU Meng-ling,WU Tai-bin.The Research of Molding Process Parameters on the Plastic Warpage's Influence[J].Journal of Netshape Forming Engineering,2010,2(6):19-23,50. |
| 成形工艺参数对塑件翘曲影响研究 |
| The Research of Molding Process Parameters on the Plastic Warpage's Influence |
| 投稿时间：2010-09-18 修订日期：2010-11-10 |
| DOI： |
| 中文关键词: 优化设计 工艺参数 翘曲 单个因素 |
| 英文关键词: design optimization molding process parameters warpage single factor |
| 基金项目:南京工程学院2008年科研基金项目（KXJ08057） |
|
| 摘要点击次数: 4484 |
| 全文下载次数: 3391 |
| 中文摘要: |
| 优化设计某型号打印机轴杆模具的浇注系统和冷却系统的研究中，以正交试验得到的一组工艺参数组合作为基准，变动其中某一个工艺参数，分析各工艺参数对翘曲变形量的影响趋势和机理。揭示单个工艺参数因素与翘曲的关系图，有利于决定更精确的成形条件，对工艺参数优化起到定量的指导意义。 |
| 英文摘要: |
| The influence and mechanism of each process factor on the warpage were studied by changing one factor at a time and keeping the others at their optimum level based on the optimum set of molding process parameters obtained through orthogonal test in the research on the optimum aim at the pouring system and temperature adjusting system of a certain printer's axostyle mould. Revealing the connection between single factor and warpage is in favor of determining more accurate molding conditions and of quantitative guiding significance for the optimization of the molding process parameters. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号