康凤,胡传凯,舒大禹,等.Al-Zn-Mg-Cu系超高强铝合金等温复合挤压研究[J].精密成形工程,2010,2(5):17-19,30.
KANG feng,HU Chuan-kai,SHU Da-yu,et al.Research on Isothermal Multiple-extrusion of Al-Zn-Mg-Cu Superduralumin[J].Journal of Netshape Forming Engineering,2010,2(5):17-19,30. |
| Al-Zn-Mg-Cu系超高强铝合金等温复合挤压研究 |
| Research on Isothermal Multiple-extrusion of Al-Zn-Mg-Cu Superduralumin |
| 投稿时间：2010-06-09 修订日期：2010-09-10 |
| DOI： |
| 中文关键词: 超高强铝合金 数值模拟 组织 等温成形 参数优化 |
| 英文关键词: superduralumin, numerical simulation, microstructure, isothermal forming, parameter optimization |
| 基金项目:总装预研资助项目(51312050107) |
|
| 摘要点击次数: 3965 |
| 全文下载次数: 3113 |
| 中文摘要: |
| 以某回转体构件为对象，进行了等温复合挤压成形研究，通过有限元数值模拟，分析了成形过程中材料的流动，并以此为基础开展了工艺试验，试验结果表明，成形与模拟情况基本相符，挤压生产出的铝合金构件充型饱满，检测尺寸满足构件的要求，外表面无折叠、裂纹等缺陷，微观组织晶粒细小且分布均匀。 |
| 英文摘要: |
| The research of isothermal multiple-extrusion was put up to a revolving part. By means of numerical simulation the flowing of the material during forming was analyzed, then the engineering tests were carried out based on it. The result indicated that the superduralumin part after isothermal multiple-extrusion was formed with good filling, without deficiency of fold or crack on the surface. In microstructure the grains were fine and well distributed. The dimension of the part also satisfied its requirements. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号