徐迎强,薛克敏,曹婷婷,等.汽车门槛内板零件冲压数值模拟及参数优化[J].精密成形工程,2010,2(3):36-40.
XU Ying-qiang,XUE Ke-min,CAO Ting-ting,et al.Numerical Simulating and Parameter Optimizing of the Stamping Forming Process of Auto Doorsill's Inner Panels[J].Journal of Netshape Forming Engineering,2010,2(3):36-40. |
| 汽车门槛内板零件冲压数值模拟及参数优化 |
| Numerical Simulating and Parameter Optimizing of the Stamping Forming Process of Auto Doorsill's Inner Panels |
| 投稿时间：2010-03-25 修订日期：2010-05-10 |
| DOI： |
| 中文关键词: 汽车覆盖件 数值模拟 参数优化 成形极限图 |
| 英文关键词: auto body numerical simulation parameter optimizing forming limit diagram |
| 基金项目: |
|
| 摘要点击次数: 4154 |
| 全文下载次数: 3332 |
| 中文摘要: |
| 针对汽车覆盖件冲压变形复杂，成形工艺参数难以确定等特点，基于DYNAFORM软件对汽车门槛内板零件的拉延成形过程，及不同工艺参数对成形结果的影响进行了研究。用优化的工艺参数进行模拟验证，从而为工艺设计和试模提供理论指导。 |
| 英文摘要: |
| Aiming at the characteristics of auto body as complicated deformation during stamping process and uncertainty of forming technical parameters, the stamping process of auto doorsill's inner panels was investigated by the software DYNAFORM. Influence of different technical parameters on the forming results was discussed. The optimized technical parameters were used to carry out simulation verification, and finally guided the design and die tryout. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号