王鑫.过滤罩多工位级进模具设计[J].精密成形工程,2010,2(2):23-26.
WANG Xin.Design of Multi-position Progressive Die for Filter Mask[J].Journal of Netshape Forming Engineering,2010,2(2):23-26. |
| 过滤罩多工位级进模具设计 |
| Design of Multi-position Progressive Die for Filter Mask |
| 投稿时间：2010-02-13 修订日期：2010-03-10 |
| DOI： |
| 中文关键词: 多工位级进模 排样 模具结构 工艺分析 |
| 英文关键词: multi-position progressive die layout die structure technical analysis |
| 基金项目: |
|
| 摘要点击次数: 4107 |
| 全文下载次数: 3141 |
| 中文摘要: |
| 分析了过滤罩的结构特点，确定了过滤罩的成形工艺方案。详细阐述了少废料单排排样设计方案，介绍了过滤罩多工位级进模具的总体结构及特点。条料通过侧刃和导正销精确定位，达到了快速、高效的冲裁效果，生产的零件质量达到要求。 |
| 英文摘要: |
| The structural characteristic of a filter mask was analyzed，and the forming technology program of the filter mask was determined. The design of layout in single-row and with few scraps was stated in detail and the total structure and characteristic of multi-position progressive die for filter mask were introduced. The strip materials were precisely oriented by side edge and pilot pin. A rapid and efficient blanking effect was achieved and the quality requirements were met. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号