刘天聪.精冲模具间隙与刃口尺寸及公差的确定方法[J].精密成形工程,2010,2(1):74-77.
LIU Tian-cong.The Method to Determine the Clearance and Edge Size and Tolerance of Fineblanking Die[J].Journal of Netshape Forming Engineering,2010,2(1):74-77. |
| 精冲模具间隙与刃口尺寸及公差的确定方法 |
| The Method to Determine the Clearance and Edge Size and Tolerance of Fineblanking Die |
| 投稿时间：2009-12-13 修订日期：2010-01-10 |
| DOI： |
| 中文关键词: 精冲模具 间隙 尺寸及公差 |
| 英文关键词: fineblanking die clearance size and tolerance |
| 基金项目: |
|
| 摘要点击次数: 4113 |
| 全文下载次数: 4445 |
| 中文摘要: |
| 分析了精冲模具间隙和断面质量并制订了间隙列线图，论述了模具加工过程的刃口尺寸控制方法及技术要求，归纳了精冲模具间隙与刃口尺寸公差的确定原则，改善了制造效果，并介绍了降低成本及缩短生产周期和简化生产工艺，提出了较详尽的精冲模具刃口尺寸公差的确定方法。 |
| 英文摘要: |
| This paper analysed the fineblanking die clearance and section quality and lay down the arrangement lines figure of the clearance. The control methods and technical specification of the edge size for the die machining process were discussed. The principles to determine properly the size and tolerance of fineblanking die edge and clearance were included. The machining result was improved. The reducing cost and shortening production cycle and simplifying process were introduced. The method to determine the size and tolerance of fineblanking die edge was presented in detail. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号