李恩轩.全纤维曲轴RR镦锻消除锻造余块的工艺探索[J].精密成形工程,2009,1(2):79-82,88.
LI En- xuan.Study on Eliminating Forging Accessorial Block of the Continuous Grain Flow Crankshaft Which Forming in the RR- equipment[J].Journal of Netshape Forming Engineering,2009,1(2):79-82,88. |
| 全纤维曲轴RR镦锻消除锻造余块的工艺探索 |
| Study on Eliminating Forging Accessorial Block of the Continuous Grain Flow Crankshaft Which Forming in the RR- equipment |
| 投稿时间：2009-06-05 修订日期：2009-09-10 |
| DOI： |
| 中文关键词: RR镦锻 TR35镦锻 锻造余块 曲柄板 |
| 英文关键词: RR- equipment TR- equipment forging accessorial block crank |
| 基金项目: |
|
| 摘要点击次数: 4021 |
| 全文下载次数: 3238 |
| 中文摘要: |
| 简述了资阳机车有限公司全纤维RR曲轴镦锻现状，并与TR工艺做了简要对比，提出了RR镦锻消除锻造余块的课题，对RR曲轴柄板余块位置及产生的原因进行了详细的分析，提出了消除余块的方案，以21/32曲轴为例对实施效果及达到的经济效益做了详细陈述，并提出了今后努力的方向。 |
| 英文摘要: |
| Based on the research of the continuous grain flow crankshaft forging in the RR- equipment and TR- equipment, the problem of eliminating forging accessorial block was brought forward. Through careful analysis of the reasons for the formation and position of forging accessorial block on the cranks, some ways to eliminating the block were found. These new techniques were applied on making the 21/31 crankshaft and good effect was obtained. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501719号